RadioLink RC8X - Safety Precautions; Packing List

RadioLink Electronic Limited
www.radiolink.com
3
 Never operate your model during adverse weather conditions. Poor visibility can cause
disorientation and loss of control of your model.
 Never use this product in a crowded and illegal area.
 This product is not a toy and is NOT suitable for children under the age of 14. Adults
should keep the product out of the reach of children and exercise caution when operating
this product in the presence of children.
 The operating voltage of RC8X is from 7.0V to 17V. Make sure the battery voltage meets
the requirement. 8 pieces AAA batteries，a 2S-4S LiPo battery or a 6S Ni-MH battery is
permitted.
 Never charge the RC8X with the USB port. The Type-C port on the left of RC8X is used to
update firmware, copy data, supply power to the 5.8G image transmission module, and
temporarily supply power to RC8X. It cannot be used to charge the battery of RC8X.
 Always be sure to turn off the receiver before the transmitter.
 Make sure the throttle trigger and trim are set to the neutral position, and then turn on the
transmitter. Check the throttle travel value of the transmitter to ensure it is in the neutral
position, and then power on the receiver.
 Before running, check if the function moves the servos to the preset position. Push the
throttle trigger and turn the steering wheel to check if the motor and servo move to the
preset position. If you notice any unusual behavior of the model, do not operate the model.
Also check to make sure the model you used matches the model in the transmitter.
Problems with the transmitter and improper installation of the model can lead to loss of
control.
 Never unplug and plug the Micro SD card when the transmitter turns on, especially the
transmitter is reading the data, or it will damage the SD card or loss of data.
The above safety warnings must be strictly implemented, and RadioLink will not be responsible
for any loss caused by not following these safety warnings.
SAFETY PRECAUTIONS
PACKING LIST
EXT Connect Cable×1 Type-C Cable×1 Hex Wrench×2 Spare Trigger×1 Screen Protector×1
RC8X Transmitter×1 R8FG Receiver×1 R4FGM Receiver×1 32G SD Card×1 Lanyard×1
(Installed in RC8X)