RadioLink RC8X - Three Position Switch; Menu Introduction; Power on RC8 X; Icon Introduction

RadioLink Electronic Limited
www.radiolink.com
8
Three Position Switch
The four DT buttons can be used as four 3 position switches by setting. The setting method is as
follows:
1．Select any DT button for the channel to be set in the "Channel Setting" menu.
2．Enter "Trim/Dial select" menu, and set the step of the corresponding DT button to 100,
so that every time the DT button is toggled, the travel amount will go directly to 100. You can also
set different values according to your needs (Note: Trim step defaults to 2).
3．After setting, the DT button can be used as a 3-position switch. Return to the home
page and toggle the corresponding DT button to check the servo display.
Power on RC8X
Long press the HOME button for about 1.5 seconds to power on RC8X. Click the icon in the
lower left corner of the home page to enter the setting page.
Icon introduction
Into setting menu
Model select menu
System menu
SD Card Folder
Basic menu
Back to previous menu
Telemetry setting
Increase the value
Racing menu
Decrease the value
Mixing setting
Reset the value
Tools menu
MENU INTRODUCTION