RadioLink Electronic Limited
www.radiolink.com
Working mode setting
1．Turn on/off the gyro: Short press the binding button 3 times within 2 seconds to switch
the gyro on and off, and the color of the LED indicator will switch accordingly.
2．Gyro phase switch: Short press the binding button twice within 2 seconds to switch the
gyro phase.
3．Turning on/off the SBUS: short press the binding button once to turn on/off the SBUS,
and the color of the LED indicator will switch accordingly. After SBUS signal is enabled, channel
1-7 output PWM, and channel 8 outputs the SBUS signal.
LED Indicator Color in Different Working Modes
Note: When the receiver is connected to the power supply, if there is no successful binding
between the receiver and the transmitter or the receiver loses the signal, the indicator of the
receiver will flash slowly.
Gyro Function of R8FG
R8FG has a built-in gyroscope. The integrated high-performance gyro adopts the software filter
and PID algorithm, timely and precisely corrects the sensitivity and improves the stability. Its
good flexibility to different models easily achieves professional performance even with drift cars.
Enable Gyro
The gyro function of R8FG is turned off by default. Since the integrated gyro in R8FG will
self-check, it is important to keep R8FG still when powering it on. Short press the binding button
3 times within 2 seconds to switch the gyro on and off, and the color of the LED indicator will
switch accordingly. Red LED indicates that gyro is enabled.
Attention: It's normal that the servo keeps shaking when connected to the receiver. Because the
gyro is helping to correct the steering gear angle of the servo automatically if the gyro function
has turned on, you can turn off the gyro function if you do not need this function.
If the receiver has not to be moved, but the servo keep shaking, there are two reasons below:
① The servo has connected to the S.BUS channel of the receiver. Please reconnect the servo to
the CH1/2/3/4/5/6/7, because the standard servo only supports PWM signal input.
② The gyro is too much sensitive. Please turn DL1 switch to reduce the gyro sensitivity.
To Next Page
Loading...
