13
Turning On Part of the System (Part On)
❏ I have this feature.
❏ I do not have this feature.
Part On turns on only a part of your system, leaving the rest of
the system turned off. Once youve pressed the 0 key, exit delay
time starts to count down. You should leave before exit delay time
expires. Leaving after exit delay expires causes an alarm event. Use
Part On when you want part of your system turned on.
1. Make sure that Part points are normal. In this example,
points 5, 6, 7, and 8 are Part points. Press the 0 key. The display
shows:
2. If all Part points are normal, exit delay time begins. If your
system has faulted points, you should return them to normal, or
refer to Bypassing Points.
3. During exit delay, you may stop the system from turning on
by pressing CLEAR.
4. When exit delay time expires, the keypad beeps three times
and then the system turns on.
5. To turn the system off, enter your personal passcode.
To Next Page
Loading...
