28
System Test
❏ I have this feature.
❏ I do not have this feature.
This feature helps to ensure that your system is operating
properly. Be sure to contact your security company before you
begin.
1. Make sure that the system is turned off.
2. Press the 1 key and enter your passcode (Owner type
required).
3. If your passcode is valid, the system test begins.
4. When the test finishes, the system returns to the off display.
Testing Points
1. To test points, use the Watch feature (see page 18 and 19).
2. Select the Watch Tone to be a short beep.
3. Select to watch All points.
4. Test each point.
WARNING: The system will not let you watch a Fire point; it
can not be tested in this manner. Trying to test a Fire point will
result in an actual Fire Alarm. Consult with your monitoring
company to determine the preferred way to test a Fire point.
To Next Page
Loading...
