7
PREFACE
About this manual
This manual is written for engineers and technicians who will integrate the Procelerant™ Endura
Q35 motherboards into their own products. For instructions on setting up an Endura Q35
motherboard, refer to the Procelerant Endura Q35 Motherboard Quick Start Guide available on
the RadiSys® Web site, www.radisys.com.
Safety notices
Electrostatic discharge
WARNING! This product contains static-sensitive components and should be handled with care.
Failure to employ adequate anti-static measures can cause irreparable damage to components.
To avoid electrostatic discharge (ESD) damage, the following precautions are strongly
recommended.
Keep each module/PCB in its ESD shielding bag until you are ready to install it.
Before touching a module, attach an ESD wrist strap to your wrist and connect its other end
to a known ground.
Handle the module only in an area that has its working surfaces, floor coverings, and chairs
connected to a known ground.
Hold modules only by their edges and mounting hardware. Avoid touching PCB
components and connector pins.
For further information on ESD, visit www.esda.org.
Lithium cell battery
WARNING!
When replacing the battery on the motherboard, use only lithium cell battery type CR2032.
Using any other battery may damage the board.
Do not use a conductive instrument to remove the battery.
Dispose of the spent battery promptly. Do not recharge, disassemble, or incinerate the battery.
Keep the battery away from children.
Where to get more product information
For additional product information, visit the motherboard product pages on the RadiSys Web site
at www.radisys.com for access to datasheets, product documentation, BIOS releases, and
drivers.
To Next Page
Loading...
