EasyManua.ls Logo

Rain Bird WPX2 - Controller Modes and Functions; Auto Run Mode; Manual Watering; Off Mode

Rain Bird WPX2
7 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WPX Battery-Operated Controller
4
Odd Days / Even Days
When ODD 1,3,5...29 (or EVEN 2,4,6...30) is blinking, press
NOTE: ODD schedules will not water on the 31st of the month.
Auto Run
Auto Run
Press the MODE button until the AUTO RUN screen is displayed.
In AUTO RUN mode, the WPX will irrigate each zone per its programmed
schedule. If any zones are scheduled to run at the same time and day,
your controller will place those zones in a queue and irrigate one valve
at a time, starting with the lowered number zone rst.
NOTE: After 5 minutes of inactivity, the controller will revert to
AUTO RUN mode (unless the controller is in OFF) and turn o the
display. Press any key to turn the display back on.
Off
Press the
button until the OFF screen is displayed.
Selecting the OFF mode will cancel any active watering and prevent any
irrigation from starting automatically.
NOTE: Select the AUTO RUN mode to resume normal operation.
Programmed irrigation schedules will NOT run if the controller is
left in OFF mode.
NOTE: If you intend to stop automatic irrigation only for a few
days, we suggest you use the “Delay Watering” feature described
in page 10.
NOTE: To re-initiate watering, press the
button again to re-
turn to AUTO RUN mode.
Manual Watering
Press the button until the Manual Watering screen is displayed.
SET
RUN
TIME
CHOOSE
ALL ZONES
OR ANY
ONE ZONE
Press + or - to select ALL Zones or ONE zone; then
press
Press
+
or
to set the Run Time for the selected Zones; then press
to begin watering.
NOTE: To water the scheduled runtime for each zone: Press
when setting manual runtime until the screen shows “SCH” MIN.
One-touch Manual Start
One-touch Manual Start
Water ALL zones immediately according to their previously
scheduled run times:
With the controller in AUTO RUN mode, press and hold
for
3 seconds to begin watering all zones that have a programmed
runtime.
Seasonal Adjust
Press the MODE button until the Seasonal Adjust screen is dis-
played.
ADJUST
SETTING
The SEASONAL ADJUST mode allows you to increase or decrease the
run times for all zones by a certain percentage (10% to 200%).
Press
+
or
to increase or decrease the setting.
NOTE: SEASONAL ADJUST applies to ALL automatic watering.
Special Features

Related product manuals