2. Route the tether strap to provide the most direct
path between the anchorage and the child seat. The
tether strap should go between the head restraint
posts underneath the head restraint. You may need
to adjust the head restraint to the upward position
to pass the tether strap underneath the head
restraint and between its posts.
3. Lift the cover (if so equipped), and attach the hook
to the square opening in the sheet metal. Tighten
the tether strap according to the child seat manu-
facturer’s instructions.
WARNING!
Never place a rear-facing child restraint in front of an
air bag. A deploying Passenger Front Air Bag can
cause death or serious injury to a child 12 years or
younger, including a child in a rear-facing child
restraint.
Crew Cab Trucks
The top tether anchorages in this vehicle are
tether strap loops located between the rear
glass and the back of the rear seat. There is
a tether strap loop located behind each seat-
ing position. Follow the steps below to attach the tether
strap of the child restraint.
Right Or Left Outboard Seats:
1. Raise the head restraint and reach between the rear
seat and rear glass to access the tether strap loop.
2. Place a child restraint on the seat and adjust the
tether strap so that it will reach over the seat back,
under the head restraint, through the tether strap
loop behind the seat and over to the tether strap
loop behind the center seat.
3.
Pass the tether strap hook under the head restraint
behind the child seat, through the tether strap loop
behind the seat and over to the center tether strap loop.
Regular Cab Tether Anchorages
1 — Tether Anchor
2 — Tether Strap Hook
3 — Tether Strap To Child Restraint
Head Restraint In Raised Position
Tether Strap Loop With Center Head Restraint In Raised
Position
Tether Strap Thr ough Outboard Tether Strap Loop
260 SAFETY
To Next Page
Loading...
