4. Attach the hook to the center tether strap loop (see
diagram). Tighten the tether strap according to the
child seat manufacturer’s instructions.
NOTE:
If there are child seats in both of the outboard (left and
right) seating positions, the tether strap hooks of both
child seats should be connected to the center tether
strap loop. This is the correct way to tether two out-
board child seats.
Center Seat:
1. Raise the head restraint and reach between the rear
seat and rear glass to access the tether strap loop.
2. Place a child restraint on the seat and adjust the
tether strap so that it will reach over the seat back,
under the head restraint, through the tether strap
loop behind the seat and over to the tether strap
loop behind either the right or left outboard seat.
3. Pass the tether strap hook under the head restraint
behind the child seat, through the tether strap loop
behind the seat and over to the right or left out-
board tether strap loop.
4. Attach the hook to the outboard tether strap loop
(see diagram). Tighten the tether strap according to
the child seat manufacturer’s instructions.
Tether Strap Thr ough Outboard Tether Strap Loop And
Attached To Center Tether Strap Loop
Tether Strap Loop With Head Restraint In Raised Position
Tether Strap Thr ough Center Tether Strap Loop
Tether Strap Thr ough Center Tether Strap Loop And
Attached To Outboard Tether Strap Loop
SAFETY 261
6
To Next Page
Loading...
