To Next Page

To Previous Page

RAM DBS II

Refrigeration Solid State Starter

8.3 Acknowledging Trips and Alarms

• If an alarm or trip condition occurs, it will be displayed regardless of the menu selected at the time it

occurs.

• The display screen will read “Alarm - Enter = Ack” or “Trip - Enter = Ack”.

• To acknowledge a trip or alarm condition, press the ENTER key.

• A message on the display screen will confirm the TRIP/ALARM has been acknowledged.

8.4 Editing Set Points

• Set points cannot be edited while in the START or RUN operating states.

• Select the SET POINT menu.

• Press the UP/DOWN keys to go to the desired parameter, then press the ENTER key to enter the “Edit”

mode. The edit code (8.1.5.6.) will flash on the display screen.

• Press the UP/DOWN keys to increase or decrease the set point value. If a subsequent key is not

pressed within 30 seconds, the previously stored value will be retained.

• To abort the edit and return to the stored value, press the SELECT key.

• To save the new value as the set point, press the ENTER key.

8.5 Confirming System Setup

• Select SYSTEM SETUP menu.

• To view the values of the settings on the DBS control board, press the UP/DOWN keys.

8.6 System Override Functions

• In the SYSTEM SETUP menu there are three functions that can be reset by an authorized operator or

technician: CLEAR THERMAL CAPACITY, CLEAR FAULT HISTORY, and LOAD FACTORY SETUP.

• To clear the memory of a function, select the function via the UP/DOWN keys, then press ENTER.

• Press the SELECT key to go to confirm selection.

8.0 DBS Control Display Unit

StockCheck.com

RAM DBS II User Manual

Questions and Answers: