RAM DBS II User Manual

RAM DBS II
Refrigeration Solid State Starter
31
Serial Number___________________
Switch Settings
(Copy settings as currently set on main control board)
(Sw Pos)
Switch 1 - FLA __________
(Sw Pos)
Switch 2 - Current Step __________
(Sw Pos)
Switch 3 - Ramp Time
__________
Switch 4 - Configuration Dip Switch
(Circle Switch Position)
Pos 1 LEFT/RIGHT
Pos 2 LEFT/RIGHT
Pos 3 LEFT/RIGHT
Pos 4 LEFT/RIGHT
Pos 5 LEFT/RIGHT
Pos 6 LEFT/RIGHT
Pos 7 LEFT/RIGHT
Pos 8 LEFT/RIGHT
Fault History Menu
Setting
Last Trip Condition ________
Last Trip Current ________ Amps
Last Trip Heatsink Temperature ________ Deg C
Last Trip Thermal Capacity ________ % Cap
Last Trip FLA ________ Amps
Last Trip Current Step ________ % FLA
Last Trip Ramp Time ________ Seconds
Last Trip Bypass Time ________ Seconds
Last Run Time ________ Minutes
Total No. of Starts ________
Total Run Time ________ Hours
Total No. of Jam Trips ________
Total No. of Short Circuit Trips ________
Total No. of Phase Loss Trips ________
Total No. of Phase Reversal Trips ________
Total No. of Current Unbalance Alarms ________
Total No. of Heatsink Temperature Trips ________
Total No. of Thermal Overload Trips ________
10.0 DBS Log
Set Point Menu
Setting
Locked Rotor Current ___________ % FLA
Stall Time ___________ Seconds
Jam Current Level ___________ % FLA
Jam Run Delay ___________ Seconds
Service Factor ___________ % FLA
Current Unbalance Level ___________ % FLA
Current Unbalance Run Delay ___________ Seconds
System Setup Menu
Setting
FLA ___________ Amps
Start Mode ___________
Constant Current Level ___________ % FLA
Ramp Time ___________ Seconds
Bypass Time ___________ Seconds
Starter Size ___________
Thermal Overload ___________
Motor Configuration ___________
Control Mode ___________
Software Version ___________
10.0 DBS Log
StockCheck.com

RAM DBS II Specifications

General

Brand	RAM
Model	DBS II
Category	Controller
Language	English