R
amsond
Instruction Manual for CT 416 and 518 D & DX Series
© Copyright RAMSOND Corporation 2007 – All rights protected. Unauthorized reproduction, in part or whole prohibited.
®
TROUBLESHOOTING
SYMPTOM CAUSE / SOLUTION
No Torch Arc or Inadequate Arc
1. Incorrect Wiring - Check Main’s Wiring
2. Power Switch off -Turn Machine on
3. No main power
4. Inadequate Air Supply - Minimum 30 psi needed
5. Torch problem -change consumables and ensure proper
assembly.
6. Torch problem - There is short in the torch wire.
7. Cutting surface not grounded and connected to the
machine - make sure ground clamp is connected
8. Cutting surface is rusty - clean the rust
9. Lower the torch closer to cutting piece
O.C. (OVER CURRENT) Light is Lit
1. Duty Cycle reached - Wait a few moments until the
machine cools down.
2. Internal component problem. See professional assistance
Page 18
To Next Page
Loading...