R
amsond
Instruction Manual for CT 416 and 518 D & DX Series
© Copyright RAMSOND Corporation 2007 – All rights protected. Unauthorized reproduction, in part or whole prohibited.
®
MISUSE
LIMITED WARRANTY VOID
IMPORTANT
Your CT series unit is equipped with three different functions. Please take note of the
following operational guidelines. Failure to adhere to the following operations guidelines
will causes severe damage to you machine and will render the Limited Warranty void.
The following is not meant to be an all inclusive list of situations where the Limited
Warranty is rendered void. It is meant to serve as an example. Please review the
remainder of this manual and the terms of Limited Warranty supplied herein for further
details.
OPERATE ONLY ONE FUNCTION AT A TIME
Using multiple functions simultaneously will lead to severe damage to the unit and render the warranty void.
DO NOT SWITCH BETWEEN FUNCTIONS DURING OPERATION
While engaged in operating one of the functions, do not switch to another function. For example, if you are engaged in
plasma cutting, do not change the toggle switch of the Function Selector to TIG or MMA.
CONFIRM CORRECT SETTING BEFORE OPERATION
Confirm that the function selector is set to the proper setting before beginning operation. For example, do not attempt
to use the plasma torch function while the machine’s Function Selector is on TIG. This will lead to serious damage to
the unit
DO NOT USE PLASMA TORCH IN MMA OR TIG MODE
Using the plasma torch while the machine is switched to the MMA or TIG function will result in damage to the plasma
torch and the CT machine.
INCORRECT WIRING
Failure to connect the CT unit correctly to the main input power source will result in severe damage to the unit and may
lead to the risk of injury, death or electrocution. Please follow the wiring diagram supplied with your machine
Page 3
To Next Page
Loading...