randellfx.com 23
2323
23
FX1- 4N1 Control Operation con’t
CONTROL KEY DESCRIPTIONS
1. UP/TEMP/MANUAL DEFROST – used to browse menu, raise temperature settings and activate
manual defrost.
2. START/STOP cycle – used to start and stop current cycle monitored by the yellow LED upper left
corner of button.
3. CYCLE selection – used to browse cycles 1 through 4 monitored by the yellow LED upper left
corner of button.
4. LIGHT button – used to switch the light on and off (this button is not used in model FX1-4N1).
5. DOWN/TEMP/CLOCK – used to browse menu, lower temperature settings and set real time clock
6. SET – used to change the set points in any cycle monitored by the yellow LED upper left corner
of button.
7. PRINTER – used to enable/disable the printer if printer is provided monitored by the yellow LED
upper left corner of button.
8. AUX – used to switch auxiliary functions on and off monitored by the yellow LED upper left
corner of button.
HOW TO SET THE REAL TIME CLOCK (RTC)
Press and hold the DOWN key until the nIn label (minutes) is displayed.
Use the UP and DOWN key or to browse the parameters.
n
I
n
= minutes
H o u
= hours
d A
y
= date day
n
o n
= date month
y
E A
= date year
t
I
n
= USA or
Europe (EU) time
MANUAL
DEFROST
TO MODIFY: Press the SET key and then the UP and DOWN
keys.
TO CONFIRM: Press the SET key.
TO EXIT THE RTC MENU: Press together the SET + UP keys or
wait 5 seconds.
To Next Page
Loading...
Need help?
General
