randellfx.com 31
3131
31
FX1-4N1 Unit Operation con’t
4. Place the cooked product in 12”x20”x2-1/2” deep pans and cover for quicker chill times.
Place one pan on the bottom shelf as shown in Figure 5 then set the second shelf on
the bracket platforms and place the second pan on top of that shelf. Each pan holds
approximately 11 lbs of product and each drawer holds two pans for a total of 22 lbs.
More then 22 lbs will require longer cycle time to bring product below 40°F.
5. HOW TO START THE RAPID CHILL CYCLE TIMED MODE
The control on your FX1-4N1 is factory set for Rapid Chill utilizing timed mode. The
timer symbol will be illuminated indicating the timed mode is set. If this is the
mode desired, proceed to the following steps to operate the Rapid Chill Timed Mode.
Press and hold the START/STOP key until the yellow LED turns off.
Press the CYCLE SELECTION key until cycle is selected.
Press the START/STOP key. The correspondent yellow LED is switched on.
The Rapid Chill mode is set and will run for 5 hours. The first 4 hours of the cycle the
system is set to run at full capacity to cool the hot food quickly. The next hour is set at a
temperature set point to stabilize the product temperature of below 40°F. After the 5
hour cycle the system will automatically go into defrost (to clear the evaporator coil)
followed by the hold cycle to maintain refrigerated temperatures of below 40°F.
6. HOW TO SET THE RAPID CHILL CYCLE FOOD PRODUCT TEMPERATURE MODE
The control on your FX1-4N1 is factory set for Rapid Chill Timed Mode. The following
steps changes to a Product Temperature Mode.
To access the PROGRAMING MODE start by pressing and holding the START/STOP
key until the yellow LED turns off.
Press together the SET +
DOWN keys until the screen changes.
Press the DOWN
key until the parameter
Pr2
(PROGRAM mode) is displayed.
Press the SET key and the letters
PAS
(PASSWORD = 321)
will display for a
short time and then
O
--
will be displayed with the
O
blinking.
Press the UP
key until
the number
3
is displayed, press the SET key.
The center
O
will be blinking, press the UP
key until
the number
2
is displayed
and then press the SET key. The right
O
will be blinking, press the UP
key until
the number
I
is displayed and then press the SET key.
To Next Page
Loading...
Need help?
General
