randellfx.com 25
2525
25
FX1- 4N1 Control Operation con’t
TO CHANGE THE TEMPERATURE SETTING FOR CYCLE
H
HH
H
(HOLD):
Follow the instructions HOW TO SET THE CYCLE OF OPERATION to cycle H
HH
H. Once this is set
perform the following steps.
Press the SET key the symbol
in yellow LED will be displayed.
Press and hold the SET key until the LED
and the yellow LED light on the SET
key left top corner is blinking.
Press the UP
key to raise the temperature.
Press the DOWN key to lower the temperature.
Temperature on the display will change either by pushing the key one increment at a time or by
holding down the key to quickly scroll through the numbers.
Once the temperature is selected press the SET key to confirm and activate this new setting.
To Next Page
Loading...
Need help?
General
