R&M CMX 007 - Page 10

4
Remove the motor connection box lid.
5
Record the dip-switch settings from the CMX 007 frequency
converter.
On pageOld inverter parameter settings (page 17) you can
find an empty table where to write the settings.
6
Remove the wire terminal by pulling. Remove the CMX 007 .
7
Remove wires from the terminal one at the time.
R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
P.: (937) 328-5100
FAX: (937) 325-5319
10/28
R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.