11
Mark the wire with markers. Use installation mandrel for easy
installation.
12
Do steps 5-9 to the rest of the wires.
4.2 Control voltage front resistors
The TMU should not have front resistors. However, if they are present, they must be removed. Do not mix the
order of the wires.
If the front resistors are not removed or by-passed, the control inputs on the
ControlMaster®NXT
003
frequency converter will not be activated, even though voltage can
be measured with a multimeter.
4.3 New frequency converter installation
1
Install the bottom plate. Use the 2 flat head screws delivered
with the package.
R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
P.: (937) 328-5100
FAX: (937) 325-5319
12/28
R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
To Next Page
Loading...