To Next Page

To Previous Page

Instrument tour

R&S

LCX Series

29Getting Started 1179.2254.02 ─ 03

The [On/Standby] lights green when the instrument is switched on, see Chap-

ter 3.10, "Switching on or off", on page 24.

4.1.3 Connectors

The measurement input connectors and the USB connector are on the front

panel.

L CUR, L POT, H CUR, H POT

Four BNC sockets:

●

"L CUR" (low current): signal output for series measurements (signal genera-

tor).

●

"L POT" (low potential): signal input for parallel measurement (voltage mea-

surements).

●

"H CUR" (high current): signal input for series measurements (current mea-

surements).

●

"H POT" (high potential): signal input and output for parallel measurements

(measurement bridge).

Ground socket

Protective ground socket (4 mm banana socket) to secure the R&S LCX, e.g. with

a grounded external conductor.

The front panel ground socket is directly connected to the mains safety ground by

the line cord.

See Table 1-1.

USB A

Female USB (universal serial bus) connector of type A (host USB). You can con-

nect a USB memory stick, e.g., to record and export measurement data, to cap-

ture screenshots, or to update the firmware.

How to: Chapter 3, "Preparing for use", on page 13

4.2 Rear panel tour

This section provides an overview of the connectors at the rear panel of the

instrument. For technical data of the connectors, see the data sheet.

Rear panel tour

R&S LCX Series Getting Started

Other manuals for R&S LCX Series