Command reference
R&S
®
ZNA
1229User Manual 1178.6462.02 ─ 20
Parameters:
<Selectivity> NORMal | HIGH | NFIGure
NORMal – IF filter with normal selectivity and short settling time.
HIGH – IF filter with highest selectivity but longest settling time.
NFIGure – IF filter particularly suitable for noise figure measure-
ments (not supported yet).
*RST: NORMal
Example: See [SENSe<Ch>:]SEGMent<Seg>:BWIDth[:
RESolution]:SELect:CONTrol
Manual operation: See "IF Filter (digital) " on page 486
7.3.14.3 [SENSe<Ch>:]CDLL...
Adds, removes and configures custom (external) DLLs.
These commands allow you to add/remove external DLLs to/from the firmware. It gives
access to their configuration, tasks, and traces.
[SENSe:]CDLL:ADD <DllPath>
Tells the analyzer firmware to load a custom (external) DLL.
The DLL and its accompanying files must be packed in a zip archive. It will be loaded
on every subsequent firmware start, until it is removed using [SENSe:]CDLL:REMove
.
Note that adding/removing custom DLLs is only possible if the firmware is run as
administrator.
Setting parameters:
<DllPath> Full path to the zip archive including the DLL (at the top-tevel).
Usage: Setting only
Manual operation: See "Add / Remove" on page 357
[SENSe:]CDLL:LIST?
Queries the loaded custom (external) DLL files.
The return value is a single string, comprising a comma-separated list of DLL names,
without the dll extension.
Use [SENSe:]CDLL:ADD/[SENSe:]CDLL:REMove to load/unload a custom DLL..
Usage:
Query only
Manual operation: See "Loaded DLLs table" on page 356
SCPI command reference
To Next Page
Loading...
