R&S ZNA50 - Page 1544

Command reference
R&S
®
ZNA
1544User Manual 1178.6462.02 ─ 20
[SENSe<Ch>:]PRANge............................................................................................................................... 1543
[SENSe<Ch>:]SLAMode..............................................................................................................................1542
[SENSe<Chn>:]FREQuency:MDELay:MSTate?..........................................................................................1539
CALCulate<Chn>:FORMat:WQPNormal.....................................................................................................1543
MMEMory:LOAD:MDAData......................................................................................................................... 1539
MMEMory:LOAD:MDCData.........................................................................................................................1539
MMEMory:STORe:MDCData.......................................................................................................................1540
SOURce<Ch>:POWer:CORRection:MIXer:IF[:ACQuire]............................................................................ 1533
SOURce<Ch>:POWer:CORRection:MIXer:LO<Stg>[:ACQuire]................................................................. 1534
SOURce<Ch>:POWer:CORRection:MIXer:RF[:ACQuire]...........................................................................1534
SYSTem:CORRection:FMPort[:STATe]........................................................................................................1543
7.4 HUMS and service date commands
This section provides the commands that are related to the Rohde & Schwarz Health
and usage monitoring service (HUMS), which is available on various Rohde & Schwarz
instruments.
For background information, see the R&S HUMS User Manual.
● SNMP/REST commands.....................................................................................1544
● System information commands...........................................................................1548
● Device tags commands.......................................................................................1558
● Utilization commands..........................................................................................1559
● Service date commands......................................................................................1562
7.4.1 SNMP/REST commands
These commands configure the SNMP and REST interfaces to R&S HUMS.
They all require software option R&S ZNA-980.
SYSTem:COMMunicate:SNMP:COMMunity:RO.............................................................. 1544
SYSTem:COMMunicate:SNMP:COMMunity:RW..............................................................1545
SYSTem:COMMunicate:SNMP:CONTact........................................................................1545
SYSTem:COMMunicate:SNMP:LOCation....................................................................... 1545
SYSTem:COMMunicate:SNMP:USM:USER....................................................................1546
SYSTem:COMMunicate:SNMP:USM:USER:ALL?........................................................... 1546
SYSTem:COMMunicate:SNMP:USM:USER:DELete........................................................ 1547
SYSTem:COMMunicate:SNMP:USM:USER:DELete:ALL................................................. 1547
SYSTem:COMMunicate:SNMP:VERSion........................................................................1547
SYSTem:COMMunicate:REST:ENABle...........................................................................1547
SYSTem:COMMunicate:SNMP:COMMunity:RO <CommunityString>
This command sets the SNMP community string for read-only access.
HUMS and service date commands