R&S ZNA50 - Page 352

GUI reference
R&S
®
ZNA
352User Manual 1178.6462.02 ─ 20
5.2.11.1 Controls on the Spectrum tab
The controls on the "Spectrum" tab allow you to select a port and one of its receivers,
and to define how the spectrum trace is calculated. The sweep parameters and other
channel settings are defined in the Chapter 5.2.11.2, "Spectrum Setup dialog",
on page 354.
Spectrum Analysis...
Opens the Spectrum Setup dialog
Measurement
Selects the physical VNA port for the spectrum measurement.
Drag one of the "Port" buttons to the diagram area to create a new spectrum trace.
Then select the "Receiver" on page 352 to be measured.
Remote command:
CALCulate<Ch>:PARameter:MEASure 'SA1' | 'SA1REF' | 'SA2' |
'SA2REF' ...
CALCulate<Ch>:PARameter:SDEFine 'SA1' | 'SA1REF' | 'SA2' |
'SA2REF' ...
Receiver
Selects which receiver of the current spectrum traces's port shall be measured
Meas softtool