R&S ZNA50 - Page 966

Command reference
R&S
®
ZNA
966User Manual 1178.6462.02 ─ 20
CALCulate<Chn>:LIMit:UPPer[:DATA]..............................................................................973
CALCulate<Chn>:LIMit:LOWer:FEED.............................................................................. 975
CALCulate<Chn>:LIMit:UPPer:FEED...............................................................................975
CALCulate<Chn>:LIMit:LOWer:SHIFt...............................................................................976
CALCulate<Chn>:LIMit:UPPer:SHIFt............................................................................... 976
CALCulate<Chn>:LIMit:SEGMent<Seg>:AMPLitude:STARt................................................976
CALCulate<Chn>:LIMit:SEGMent<Seg>:AMPLitude:STOP................................................976
CALCulate<Chn>:LIMit:SEGMent:COUNt?.......................................................................977
CALCulate<Chn>:LIMit:SEGMent<Seg>:FORMula............................................................977
CALCulate<Chn>:LIMit:SEGMent<Seg>:FORMula:STATe..................................................978
CALCulate<Chn>:LIMit:SEGMent<Seg>:INTerpol............................................................. 978
CALCulate<Chn>:LIMit:SEGMent<Seg>:STIMulus:STARt..................................................979
CALCulate<Chn>:LIMit:SEGMent<Seg>:STIMulus:STOP.................................................. 979
CALCulate<Chn>:LIMit:SEGMent<Seg>:TYPE................................................................. 979
CALCulate<Chn>:LIMit:SOUNd[:STATe]...........................................................................980
CALCulate<Chn>:LIMit:STATe.........................................................................................980
CALCulate<Chn>:LIMit:STATe:AREA............................................................................... 981
CALCulate<Chn>:LIMit:TTLout<Pt>[:STATe]..................................................................... 981
CALCulate:LIMit:CIRCle:FAIL:ALL? [<RecallSet>]
Returns a 0 or 1 to indicate whether or not the circle limit check has failed for at least
one channel in the referenced recall set. 0 represents pass and 1 represents fail
Query parameters:
<RecallSet> Recall set name; if omitted the active recall set is used
Usage: Query only
Manual operation: See "Limit Check" on page 446
CALCulate:LIMit:FAIL:ALL? [<RecallSet>]
Returns a 0 or 1 to indicate whether or not the limit line check has failed for at least
one channel in the referenced recall set. 0 represents pass and 1 represents fail.
Query parameters:
<RecallSet> Recall set name; if omitted the active recall set is used
Usage: Query only
Manual operation: See "Limit Check" on page 432
CALCulate:LIMit:FAIL:DATA? <TraceName>, <LimitFailType>
Returns those sweep points that have caused a limit violation of the given <LimitFail-
Type> for trace <TraceName>.
Query parameters:
<TraceName> Trace name, uniquely identifying the related trace
<LimitFailType> LIMit | RIPPle | CIRCle
Limit (fail) type
SCPI command reference