R&S ZNL4 - General Network Settings

Network and remote settings
R&S
®
ZNL/ZNLE
155User Manual 1178.5966.02 ─ 20
8.4.1 General network settings
Access: [SETUP] > "Network + Remote" > "Network" tab
The R&S ZNL/ZNLE can be operated in a local area network (LAN), for example to
control the instrument from a remote PC or use a network printer.
Network settings can only be edited in the firmware if a LAN cable is connected to the
R&S ZNL/ZNLE.
Risk of network problems
All parameters can be edited here; however, beware that changing the computer name
has major effects in a network.
For details, see Chapter 8.5, "How to set up a network and remote control",
on page 164.
Computer Name..........................................................................................................156
IP Address...................................................................................................................156
Subnet Mask............................................................................................................... 156
DHCP..........................................................................................................................156
Network Configuration.................................................................................................156
Network and remote control settings