R&S ZNL4 - Hcopy:page:count:state; Hcopy:page:margin:bottom; Hcopy:page:margin:left; Hcopy:page:margin:right

Command reference
R&S
®
ZNL/ZNLE
594User Manual 1178.5966.02 ─ 20
HCOPy:PAGE:COUNt:STATe <State>
This command includes or excludes the page number for printouts consisting of multi-
ple pages (HCOPy:CONTent on page 590).
Parameters:
<State> 1 | 0 | ON | OFF
1 | ON
The page number is printed.
0 | OFF
The page number is not printed.
*RST: 1
Example:
HCOP:PAGE:COUN:STAT ON
Manual operation: See "Print Page Count" on page 107
HCOPy:PAGE:MARGin:BOTTom
<Bottom>
This command defines the margin at the bottom of the printout page on which no ele-
ments are printed. The margins are defined according to HCOPy:PAGE:MARGin:UNIT
on page 595.
Parameters:
<Bottom> *RST: 4.23 mm
Example:
HCOP:PAGE:MARG2:BOTT 2
Manual operation: See "Margins" on page 114
HCOPy:PAGE:MARGin:LEFT <Left>
This command defines the margin at the left side of the printout page on which no ele-
ments are printed. The margins are defined according to HCOPy:PAGE:MARGin:UNIT
on page 595.
Parameters:
<Left> *RST: 4.23 mm
Example:
HCOP:PAGE:MARG2:LEFT 2
Manual operation: See "Margins" on page 114
HCOPy:PAGE:MARGin:RIGHt <Right>
This command defines the margin at the right side of the printout page on which no
elements are printed. The margins are defined according to HCOPy:PAGE:MARGin:
UNIT on page 595.
Parameters:
<Right> *RST: 4.23 mm
Example:
HCOP:PAGE:MARG2:RIGH 2
Common instrument commands