R&S ZNL4 - SCPI Command Reference

Command reference
R&S
®
ZNL/ZNLE
645User Manual 1178.5966.02 ─ 20
remote control command syntax, because it allows the active trace in a particular chan-
nel to be referenced by means of the channel suffix. To keep the syntax transparent,
<Ch> is used for channel settings (it denotes the configured channel), whereas <Chn>
is used for trace settings (it denotes the active trace in the channel).
11.5.2 SCPI command reference
The following sections provide detailed reference information on the instrument con-
trol commands implemented by the R&S ZNL/ZNLE network analyzer.
● CALCulate commands.......................................................................................... 645
● CONFigure commands......................................................................................... 802
● CONTrol commands............................................................................................. 810
● DIAGnostic commands......................................................................................... 812
● DISPlay commands...............................................................................................812
● FORMat commands..............................................................................................833
● HCOPy commands............................................................................................... 834
● INITiate commands............................................................................................... 838
● INSTrument commands........................................................................................ 841
● LAYOut commands............................................................................................... 842
● MMEMory commands........................................................................................... 842
● OUTPut commands...............................................................................................872
● PROGram commands...........................................................................................876
● [SENSe:] commands.............................................................................................880
● SOURce commands............................................................................................. 973
● STATus commands............................................................................................... 998
● SYSTem commands............................................................................................1001
● TRACe commands..............................................................................................1018
● TRIGger commands............................................................................................1021
11.5.2.1 CALCulate commands
The CALCulate... commands perform post-acquisition data processing. Functions
in the SENSe subsystem are related to data acquisition, while the CALCulate subsys-
tem operates on the data acquired by a SENSe function.
● CALCulate:CALValidate........................................................................................ 646
● CALCulate:DATA...................................................................................................648
● CALCulate:FILTer[:GATE]..................................................................................... 658
● CALCulate:LIMit....................................................................................................663
● CALCulate:MARKer.............................................................................................. 681
● CALCulate:MATH..................................................................................................704
● CALCulate:PARameter..........................................................................................709
● CALCulate:RIPPle.................................................................................................718
● CALCulate:STATistics........................................................................................... 726
● CALCulate:TRANsform.........................................................................................735
● CALCulate... (other).............................................................................................. 796
VNA command reference