R&S ZNL4 - Calculate<Chn>:Marker:mpeak:excursion; Calculate<Chn>:Marker:mpeak:excursion:state; Calculate<Chn>:Marker:mpeak:threshold

Command reference
R&S
®
ZNL/ZNLE
695User Manual 1178.5966.02 ─ 20
Example: Suppose that the active channel setup contains an active trace
no. 1.
CALC:MARK:REF:MODE DISC
CALC:MARK2:REF:MODE CONT
Create the reference marker in discrete mode and marker 2 in
continuous mode.
CALC:MARK:REF ON; :CALC:MARK2 ON
Display the two markers. Due to the different modes the horizon-
tal positions can be different.
Manual operation: See "Discrete" on page 453
CALCulate<Chn>:MARKer:MPEak:EXCursion
<TargetSearchVal>
Defines a minimum excursion value for multiple peak searches.
Use CALCulate<Chn>:MARKer:MPEak:EXCursion:STATe to activate it.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Value> Minimum peak excursion
The unit is derived from the active trace format and cannot be
modified. Changing the trace format resets the excursion to a
format-specific default value.
Manual operation: See "Excursion Settings" on page 465
CALCulate<Chn>:MARKer:MPEak:EXCursion:STATe <Boolean>
Activates or deactivates the minimum excursion for multiple peak searches.
Use CALCulate<Chn>:MARKer:MPEak:EXCursion to set the minimum peak excur-
sion.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Active> Boolean
Manual operation: See "Excursion Settings" on page 465
CALCulate<Chn>:MARKer:MPEak:THReshold <Value>
Defines a threshold value for multiple peak searches.
Use CALCulate<Chn>:MARKer:MPEak:THReshold:STATe to activate it.
Suffix:
<Chn>
.
Channel number used to identify the active trace
VNA command reference