VNA GUI reference
R&S
®
ZNL/ZNLE
438User Manual 1178.5966.02 ─ 20
The active trace must be cartesian and the "Format" of the imported trace must be
the same as the "Format" of the active trace.
●
"Import File..." opens a dialog to load a limit line from a trace file (see Chap-
ter 10.6.11, "Trace Data tab", on page 386).
In case the selected file contains more than one trace, another popup dialog lets
you select the adequate one:
Imported traces are polygonal curves with n points and n – 1, where n is the "Number
of Points" of the imported trace (seeChapter 10.5.1, "Sweep Params tab",
on page 325). The n – 1 segments are appended to the current segment table for fur-
ther editing. Existing limit line segments are not overwritten.
Display Lines softtool
To Next Page
Loading...
