R&S ZNL4 - Page 63

Getting Started
R&S
®
ZNL/ZNLE
63User Manual 1178.5966.02 ─ 20
Figure 4-8: Adding a new channel setup
6. Create a new channel setup for I/Q analysis:
a) Press the [Mode] key.
b) Tap the "IQ Analyzer" button to activate a channel setup for the I/Q Analyzer
application.
c) Tap the "Display Config" softkey to activate the SmartGrid mode.
d) Drag the "Real/Imag (I/Q)" icon from the evaluation bar to the SmartGrid.
Figure 4-9: Inserting a Real/Imag diagram for I/Q analysis
e) Close the SmartGrid mode.
Trying out the instrument