R&S ZNL4 - Page 883

Command reference
R&S
®
ZNL/ZNLE
883User Manual 1178.5966.02 ─ 20
[SENSe<Ch>:]BANDwidth[:RESolution]:SELect <Selectivity>
[SENSe<Ch>:]BWIDth[:RESolution]:SELect <Selectivity>
Defines the selectivity of the IF filter for an unsegmented sweep. The value is also
used for all segments of a segmented sweep, provided that separate selectivity setting
is disabled
([SENSe<Ch>:]SEGMent<Seg>:BWIDth[:RESolution]:SELect:CONTrol
OFF).
Note: For the R&S ZNLE always NORMal selectivity filters are used. Trying to set the
selectivity will result in an execution error.
Suffix:
<Ch>
.
Channel number
Parameters:
<Selectivity> NORMal | MEDium | HIGH
NORMal – IF filter with normal selectivity and short settling time.
MEDium – IF filter with steeper edges and longer settling time.
HIGH – IF filter with highest selectivity but longest settling time.
*RST: NORMal
Example: See [SENSe<Ch>:]SEGMent<Seg>:BWIDth[:
RESolution]:SELect:CONTrol
Manual operation: See "Selectivity " on page 323
[SENSe:]CORRection:CKIT...
The [SENSe:]CORRection:CKIT... commands deal with calibration kits and cal kit
data. The calibration kits are distinguished by their names (<CalkitName>), the optional
labels (<label>) can be used to carry information about the calibration standard.
In order to handle several identical calibration kits with different serial numbers use the
commands of "[SENSe:]CORRection:CKIT... with Labels" on page 891.
[SENSe:]CORRection:CKIT:<StandardType>.................................................................... 884
[SENSe:]CORRection:CKIT:CATalog?.............................................................................. 887
[SENSe:]CORRection:CKIT:DELete................................................................................. 887
[SENSe:]CORRection:CKIT:DMODe................................................................................ 888
[SENSe:]CORRection:CKIT:LABel................................................................................... 888
[SENSe:]CORRection:CKIT:SELect................................................................................. 889
[SENSe:]CORRection:CKIT:<ConnType>:SELect.............................................................. 889
[SENSe:]CORRection:CKIT:STANdard:CATalog?.............................................................. 890
[SENSe:]CORRection:CKIT:STANdard:DATA?.................................................................. 890
VNA command reference