34
6 Electrical connection
CAUTION
Improper installation can lead to personal inju-
ry or property damage!
Customer: provide accessible all-pole discon-
nect unit with at least 3 mm contact separation
(disconnect switch or circuit breaker).
If unit must be connected to an earth leakage
circuit breaker, consult with the NEC code for
specific values according to KW of attached load
for selection of valves.
Before disconnecting unit or reconnecting it
again be sure the unit is switched off prior.
Remove the left side panel to access the connec-
tion port.
Removing the left side panel > Remove the two screws on the bottom of the
left side panel.
> Pull the left side panel down from the unit.
> Remove the left side panel.
To Next Page
Loading...
Need help?
General
