Rational SCC_WE User Manual

- 47 - V02 en, SCC_WE
Basic settings - Content
Water Status Factory Setting, Detected values
CDS sensor 1000 1000
Volume steam generator new after
manual descaling
XX l
Volume steam generator new after
steam generator replacement
XX l
SC pump: set pump duration X sec
SC pump: mode Continuous oder Puls
SC pump: set interval time X min
Quenching temperature hot air XX°C
Quenching temperature steam XX°C
Cleanjet / Care
Drain valve Start t1 XX s, t2 xx s
Steam corrosion control "on" oder "off"
Softwater „on“ oder „off“
Care Control Reset
Phone numbers, UltraVent, Selftest
Service Phone Setting edit
Chef line phone setting edit
Deactivate UltraVent deact
Selftest off
Deactivate interior light on - off
Gassystem Data
Gas type Nat. H
RPM Correction Selftest - P1 cold - Factory value
Ultravent on / off
Gasblower speed steam Start rpm XXXX (factory XXXX)
Gasblower speed steam Min rpm XXXX (factory XXXX)
Gasblower speed steam Max rpm XXXX (factory XXXX)
Gasblower speed hot air top Start rpm XXXX (factory XXXX)
Gasblower speed hot air top Min rpm XXXX (factory XXXX)
Gasblower speed hot air top Max rpm XXXX (factory XXXX)
Gasblower speed hot air bottom Start rpm XXXX (factory XXXX)
Gasblower speed hot air bottom Min rpm XXXX (factory XXXX)
Gasblower speed hot air bottom Max rpm XXXX (factory XXXX)

Rational SCC_WE Specifications

General

Brand	Rational
Model	SCC_WE
Category	Oven
Language	English