Instruction manual
RAVAGLIOLI S.p.A.
RAVTD1760 WS – RAVTD1780 WS
Code M0197 - rev.1.0
(11/2010)
RAVAGLIOLI S.p.A. - Via I° Maggio, n° 3 (Pontecchio Marconi)
Page 9/52
40037 Sasso Marconi (Bologna - Italy)
Tel. 051/ 67.81.511 – Fax 051/ 84.64.67 E-mail: rav@ravaglioli.com
3.6.4 Detector Keypads
Figure 5
KEYS DESCRIPTION
Detector switch-on key.
If pressed at the same time, they allow detector
manual switching off.
Legend of Figure 5:
A -
• Green LED on:
detector battery is under charge
B -
• Red LED steady on:
detector is on
• Red LED flashing:
detector is flat (when battery residual charge is
lower than or equal to 30%); it will turn off after
a few minutes
3.6.5 LED indicating Levelling and Tolerance during Adjustment
Detectors (see par. 3.6.1 and 3.6.2) are equipped with LED indicators for their correct
levelling and for tolerance during adjustment.
Levelling indicator
• RED LED on Æ detector is not levelled
• RED LED flashing and GREEN LED steady on Æ detector is close, but not levelled
• GREEN LED ONLY is flashing Æ detector is levelled
• RED LED flashing and GREEN LED steady on Æ detector is close, but not levelled
• RED LED on Æ detector is not levelled
Tolerance indicator during adjustment
• GREEN LED flashing Æ measurement is within tolerance, exactly at the centre
• RED LED flashing and GREEN LED steady on Æ measurement is within
tolerance
• RED LED on Æ measurement is NOT within tolerance
Note: during front adjustment, if you want to observe tolerance onto LEDs, take the red selection
frame on the value you are adjusting (see 8.12 on page 37).
During rear adjustment, on the contrary, tolerance is indicated both on horizontal LEDs (toe) and
vertical LEDs (camber).
LEDs on
FRONT
detectors
Tolerance
TOE or
CAMBER or
CASTER
LEDs on
REAR
detectors
RAVTD1780WS , only
CAMBER tolerance
TOE tolerance
(A) Green LED
(B) Red LED
To Next Page
Loading...
Need help?
General
