Instruction manual
RAVAGLIOLI S.p.A.
RAVTD1760 WS – RAVTD1780 WS
Code M0197 - rev.1.0
(11/2010)
Page 32/52
RAVAGLIOLI S.p.A. - Via I° Maggio, n° 3 (Pontecchio Marconi)
40037 Sasso Marconi (Bologna - Italy)
Tel. 051/ 67.81.511 – Fax 051/ 84.64.67 E-mail: rav@ravaglioli.com
8.6 Measurement Preliminary Operations
After having carried out the Run-Out procedure as explained in par. 8.5 on page 24, vehicle
shall be prepared for measurement readings. The following screen will be displayed:
Figure 44
DETECTOR
KEYPAD
PC KEYBOARD DESCRIPTION
It goes back to Run-Out
procedure
(par. 8.5 on page 24)
It continues to the alignment
procedure
(par. 8.7 on page 33)
1) Lower vehicle so as to make wheels rest on lift platforms (of course, only if the Run-Out
procedure has been carried out with raised wheels)
2) Release front plates, and any rear platform
3) Brake wheels with hand brake, and lock brake pedal with the special tool (this operation
is necessary when carrying out a steering for kingpin correct calculation).
4) Settle vehicle front and rear ends (this operation shall be carried out only if the Run-Out
with raised wheels procedure has been performed).
Press
to continue.
c
Lower vehicle so
that wheels rest
onto lift platforms
d
Release front
plates, and any
rear platform
e
Lock brake pedal
using the special
tool.
f
Settle vehicle front
and rear ends
To Next Page
Loading...
Need help?
General
