Ravaglioli RAVTD1760 WS User Manual

Instruction manual
RAVAGLIOLI S.p.A.
RAVTD1760 WS – RAVTD1780 WS
Code M0197 - rev.1.0
(11/2010)
RAVAGLIOLI S.p.A. - Via I° Maggio, n° 3 (Pontecchio Marconi)
Page 29/52
40037 Sasso Marconi (Bologna - Italy)
Tel. 051/ 67.81.511 – Fax 051/ 84.64.67 E-mail: rav@ravaglioli.com
8.5.1 Inclinometer-controlled Thrust Run-Out
Inclinometer control during the thrust Run-Out procedure is used to measure more
accurately the rotation angle pertaining to the calculation.
From the Run-Out configuration menu, set – Thrust Run-Out Æ “inclinometer”.
Lower the reference detector (usually it is the left front one) until its end is almost touching
the ground, then lock it in place.
RELEASE the other detectors, so that they are free to
oscillate upon wheel movement. When finished, press central key to confirm.
Figure 37
Move vehicle back, very slowly, until reference sensor reaches the target position (end up -
see Figure 38). When finished, press central key to confirm.
Figure 38
Position reference sensor horizontally - clearly levelled - and, when finished, press central key
to confirm.
Vehicle thrust
direction (back)
Reference
sensor target
position
Vehicle target
point
Reference
sensor start
position
Vehicle
starting point

Ravaglioli RAVTD1760 WS Specifications

General

Brand	Ravaglioli
Model	RAVTD1760 WS
Category	Wheel Balancers
Language	English