Instruction manual
RAVAGLIOLI S.p.A.
RAVTD1760 WS – RAVTD1780 WS
Code M0197 - rev.1.0
(11/2010)
Page 38/52
RAVAGLIOLI S.p.A. - Via I° Maggio, n° 3 (Pontecchio Marconi)
40037 Sasso Marconi (Bologna - Italy)
Tel. 051/ 67.81.511 – Fax 051/ 84.64.67 E-mail: rav@ravaglioli.com
8.13 Additional Functions Menu
To carry out some additional operations or to repeat some of programme phases (in case they
have not given satisfactory outcomes or have not been carried out at all), select F3
from the FRONT AXLE ADJUSTMENT page (see par. 8.12 on page 37).
You will access an additional function menu allowing carrying out the following procedures:
PRELIMINARY OPERATIONS: see par. 8.4.1 on page 23
TOE CURVE: Toe curve can be adjusted by following the displayed figures, as follows:
- Settle vehicle, press F4
- Position the special tool under front axle, press F4
- Adjust front partial toe, as recommended by the manufacturer, press F4
- Remove tool from axle, and press F4. Programme will go back to the adjustment phase.
CHASSIS DIAGNOSIS: A graphic-geometrical representation of the axles of the vehicles you
are working on can be displayed.
DATABASE: It allows displaying vehicle selection page (8.2 on page 19) and, if needed,
selecting a different vehicle
CASTER ADJUSTMENT: see par. 8.12 on page 37.
Figure 53
DETECTOR
KEYPAD
PC KEYBOARD DESCRIPTION
It goes back to front
adjustment page
(par 8.12. on page 37)
It moves selection up.
It moves selection down.
It confirms selection.
To Next Page
Loading...
Need help?
General
