How to fix corroded pins in CANbus connections in Raven Cruizer II?
Check CANbus cable connectors for any highly corroded pins. Also, ensure dielectric grease has been applied to all cable connections exposed to weather and field conditions.
What to do if CANbus ends are not terminated on Raven Cruizer II?
Make sure that both ends of the CANbus system are properly terminated.
What to do if there is moisture in connection of Raven Cruizer II GPS?
Check CANbus cable connectors for any corroded pins. Ensure dielectric grease has been applied to all cable connections exposed to weather and field conditions.
What to do if connectors are not seated properly on Raven Cruizer II?
Check that all CANbus cable connectors are inserted fully until the locking tab is engaged. Remove any moisture in connections which were not properly seated, check for corroded pins and apply dielectric grease when reconnecting CANbus cables.
General| WAAS Enabled | Yes |
|---|---|
| GPS Receiver | SiRFstar III |
| GPS Accuracy | 3 meters |
| GNSS signals tracked | GPS |
| Horizontal Accuracy | 3 meters |
| Battery | 2 AA batteries |
Describes icons for starting jobs, accessing tools, shutting down, and ending jobs on the Home Screen.
Displays icons for optional systems like AccuBoom, SmartYield, and SmarTrax detected by the console.
Guides users to start a new job, select options like New Job and AccuBoom, and name the field operation.
Describes guidance display modes: 3-D View, 2-D View, and Field Review Mode for viewing coverage.
Details the process of setting up A-B guidance lines by defining points A and B for field navigation.
Displays field boundaries (blue line) and AccuBoom zones (yellow line) recorded during the active job.
Details icons for zoom and pan lock functionality used within Field Review Mode for navigation.
Allows adding markers to specific points of interest like well heads or rock piles during a job.
Provides quick access to Favorites, System, GPS, Computer, and Vehicle menus from the Tools Menu.
Allows setting up and accessing frequently used tools for quick access.
Configures system settings like history toggling, tilt module calibration, and baud rates for communication.
Explains how AccuBoom monitors GPS and coverage map considering look ahead times for section control.
Defines the acceptable coverage tolerance for AccuBoom automatic section control.
Allows overriding automatic section control to force sections on for a user-defined time.
Sets up output of coverage map files in formats like BMP, SHP, or KML.
Obtains coverage map files for closed jobs by reconfiguring output or changing file types.
Configures the Cruizer II RTK console to receive RTK corrections from a source like Slingshot Field Hub.
To Next Page
