Why SC1/TC1 system cannot be enabled on Raven Control Systems?
The SC1/TC1 system cannot be enabled because the SC1/TC1 disengage sensor is out of range or disconnected. Reconnect or adjust the SC1/TC1 disengage sensor.
What to do if operator presence switch is disconnected on Raven Control Systems?
If the operator presence switch is disconnected, reconnect the operator presence switch.
What to do if machine speed exceeds maximum auto-steer speed on Raven Farm Equipment?
If the machine speed exceeds the maximum auto-steer speed, causing auto-steering to disengage, reduce the machine speed below the maximum engage speed and then re-engage auto-steering.
What to do if the master switch is set to 'road mode' on Raven CRX?
If the SC1/TC1 system cannot be enabled because the master switch is set to “road mode,” toggle the master switch to “field mode.”
Why the RS1 system cannot be engaged in this state on my Raven Farm Equipment?
The RS1 system cannot be engaged because there are active diagnostic and troubleshooting codes present.
What happens if the RS1 system can be engaged but performance is degraded on Raven Farm Equipment?
The RS1 system can still be engaged, but its performance quality might be degraded because active diagnostic and troubleshooting codes are present.
General| Operating System | Android |
|---|---|
| Touchscreen | Yes |
| GPS | Yes |
| ISOBUS Compatibility | Yes |
| Connectivity | Wi-Fi, Bluetooth |
To Next Page