4
P/N 016-0171-655 Rev. D 19
NOZZLE CONTROL VALVE INSTALLATION
FIGURE 8. Boom Stop
2. Place two boom stop spacers (P/N 107-0172-609) behind the boom stop.
NOTE: Boom stop spacer color may
FIGURE 9. Installed Boom Spacers
3. Use the longer bolt provided in the kit (P/N 311-0070-014) and the original nuts and washers to secure the
boom stop and spacers.
VALVE MOUNTING INTERFERENCE AND OBSTRUCTIONS
In some locations on the spray boom, boom equipment or hardware may interfere with mounting the Hawkeye
®
nozzle control valves. In these locations, there are a few options to get around the interferences:
1. Rotate the nozzle control valve so the round, low profile side of the NCV is towards the interference.
To Next Page
Loading...
