Disassembly For DMC Change
Assembly Instructions
Tools: 5mm Allen bit (long) impact driver 10mm wrench
4mm Allen bit (long) Phillips head screwdriver 13mm wrench
Parts: Hex socket screw M5 x 12 (90111-0TY0500-0001) (2)
Hex socket screw M6 x 16 (90111-0TY0200-0001) (4)
Seat console (82041-H200100-0001) (1)
Left side cover (82311-H200100-0001) (1)
Clamp nut (M5) 90679-0TY0200-0002 (if needed)
(1) To remove (1) seat console (82041-H200100-0001) off of unit. Using an Impact Drill, with a
5mm Allen Bit, Remove (2) M6x16 hex socket screws (90111-0TY0200-0001) and, using an
Impact Drill, with a 4mm Allen Bit, Remove with (2) M5x12 hex socket screws (90111-
0TY0500-0001).
(2) To remove the side panels (1) left side cover (82311-H200100-0001) attached to bracket
using an Impact Drill, with a 5mm Allen Bit, Remove both (2) M6x16 hex socket screws
(90111-0TY0200-0001).
Denver Global Products 1000 East Powell Dr. | Lincolnton, NC 28092 U.S.A
© 2013 Denver Global Products | RATO All rights reserved.
To Next Page
Loading...