Raven MPV-7100 - Tools; Removing the Battery

Oil Drain Plug
D
Bolt
Battery
Pack
10mm Wrench
E
HD 48V DC Plug
F
48 Volt Battery Removal
Work Instructions
Tools:
• 8 mm T-Handle
• 10mm Wrench
• Jack
• Battery Tray
Parts:
• Battery Tray
Removing the Battery
IMPORTANT: Turn off power & remove key.
1. Tighten oil plug by hand (Figure A).
2. Center jack under battery tray assembly located at the
rear of vehicle. Raise jack until unit is just beginning to
lift up (Figure B).
Oil Plug
A
8mm Wrench
Screw
Battery Tray
Assembly
Jack
B
3. Use the 8mm wrench or T-Handle to remove the
screw that connects the oil drain plug to the battery
pack assembly (Figure C).
4. Pull up on oil plug, place it on unit frame back left
corner (Figure D).
5. Remove all four (4) 10mm bolts using the 10mm
wrench - two on each side - connecting the battery
pack assembly to the vehicle (Figure E).
6. Unplug HD 48V DC plug (Figure F).
7. Slowly lower the jack while stabilizing the battery pack
assembly to prevent it from falling (Figure G).
Battery Pack
Assembly
Oil Drain Plug
C
Battery Pack
Jack
G
Denver Global Products 1000 East Powell Dr. | Lincolnton, NC 28092 U.S.A
© 2013 Denver Global Products | RATO All rights reserved.