Raven MPV-7100 - Service & Maintenance

Fuel Gauge Inspection on the Finished MPV
Work Instructions
Fuel Gauge Inspection on the Finished
MPV
1.
Check and see if the wiring connection of the fuel
gauge is complete and correct. Please refer to
the
following picture of wiring connection (see Figure A).
12V / red wire and GND / black wire are
connected
to the red wire and black wire of the wiring harness
2.
subline respectively.
GND / black wire is also
connected to the black wire of the fuel gauge and the
signal wire / yellow wire is connected to the
yellow
wire of the fuel sensor. The brown wire is
connected
to the orange wire of the subline (see Figure B).
Denver Global Products 1000 East Powell Dr. | Lincolnton, NC 28092 U.S.A
© 2013 Denver Global Products | RATO All rights reserved.
Brown Wire
12V / Red Wire
Signal wire /
yellow wire
GND / Black
Wire
B
Connection wire of the
subline
Connection wire of fuel sensor
A