Un-Connecting the Blade Motor Controller
Installation Instructions
• 10 mm driver
• Utility knife
Instruction Text
1. Remove the protective covers with Phillips
screwdriver.(Fig A)
2. The yellow junction box covers should be
removed. Please observe the junction box with
the opt coupler.(Fig B)
3. Also the motor sensor plug and the 12 volt
signal plugs should be unplugged.(Fig D)
4. To remove the motor controller- Mounting nut is
10mm and under is 5mm Allen button head.
5. Picture in figure (F) shows the unconnected
deck.
Denver Global Products 1000 East Powell Dr. | Lincolnton, NC 28092 U.S.A
© 2014 Denver Global Products | RATO All rights reserved.
To Next Page
Loading...