Raven MPV-7100 - Oil Separator Filter; Replacing the Oil Separator Filter; Replacement Instructions

Oil Separator Filter
Replacement Instructions
Tools:
• Needle-nose Pliers
• Zip Tie Gun (set at minimum tension)
Parts:
• New Oil Separator Filter
• 8” Zip Tie (x1)
Replacing the Oil Separator Filter
IMPORTANT: Turn off power & remove key.
1.
Open the unit rear hatch to locate the old oil separator
filter on top of the engine (Fig. A).
Locate black hose strap and bend it up and away
from
hose (Fig. B).
Use needle-nose pliers to compress the hose
clamp
nearest to strap and pull filter from hose (Fig. C).
IMPORTANT: When disconnecting the hoses from
the filter, it is recommended that the hose clamp is
completely compressed and slid back approximately
1” (Fig. D). This will allow for easier separation.
Carefully pull under existing cables/wiring
and
disconnect the other end of the filter from the
hose
connected to the fuel pump (Fig. E).
2.
3.
4.
Use needle-nose pliers to connect the top of the new
oil
separator filter to the hose connected to the fuel
pump
(Fig. G).
Hose
Clamp
Compress
and Slide
Back 1”
5.
D
Denver Global Products 1000 East Powell Dr. | Lincolnton, NC 28092 U.S.A
© 2013 Denver Global Products | RATO All rights reserved.
Needle-nose
Hose Pliers
Clamp
New Oil
Separator
Filter
F
Hose
Clamp
Needle-nose
Pliers
E
Needle-nose
Pliers
Hose
Clamp
Disconnect
Hose
Old Oil
Separator
Filter
C
Bend Up
Hose
Stra
p
H F
Engine
B
Hose Strap
Old Oil
Separator
Hose Clamps
Filter
A