Fuel Gauge Replacement
Installation Instructions
Instruction Text
1. After removal of front plastics locate the fuel
gauge assembly. (Fig A)
2. Use a 10mm driver to remove the fuel gauge
fasteners. (Fig B)
3. Remove the heat shrink to expose the
connector.(Fig C)
4. After the wires are removed from the fuel
gauge the screws on the face can be removed
the screws are the securing lock.(Fig D)
5. The fuel gauge can then be removed from the
plastics.(Fig E)
6. Repeat steps for reassembly.
Denver Global Products 1000 East Powell Dr. | Lincolnton, NC 28092 U.S.A
© 2014 Denver Global Products | RATO All rights reserved.
To Next Page
Loading...