17
3. SELF TEST FEATURE
SELF TEST allows speed simulation for testing the system while the vehicle is
not moving. Enter the simulated operating speed by depressing the key labelled
for 5 seconds. Display will show "-tESt-". If 6 MPH [9.6 km/h] is desired,
enter 6.0 [9.6] (See CONSOLE PROGRAMMING). Verify SPEED by depressing key
labelled
. The display will show 6.0 [9.6]. The SELF TEST speed will clear
itself when motion of vehicle is detected by the Speed Sensor. A SPEED CAL value
of 900 [230] or greater is recommended when operating in this mode.
NOTE:NOTE:
NOTE:NOTE:
NOTE: To prevent nuisance clearing of self-test speed, disconnect speed
connector on back of the Console when Radar Speed Sensors are used.
4. ALARM MENU
1)1)
1)1)
1) To display ALARM MENU, depress key labelled for 5 seconds. "A on" will
show in the DATA display.
a)a)
a)a)
a) Momentarily depressing
toggles the display between "A on" and "Aoff".
"A on" means alarm is enabled, "A off" means alarm is disabled.
5. OFF TARGET ALARM
Alarm sounds when the actual rate is off from the target rate by a specified
percentage. The Off Target value is preset to 30%, but may be changed to a different
number.
1)1)
1)1)
1) Adjusting Off Target value.
a)a)
a)a)
a) Depress
for 5 seconds. Display will show "or". Enter desired new
number for OFF TARGET ALARM.
b)b)
b)b)
b) Depress
to store selection.
To Next Page
Loading...
Need help?
General
