RG55 Operation • Service • Maintenance
800.392.2686
25
Operation
Command Cut ®
To adjust the command cut speed when using a RG55, adjust
the needle valve (15) below the operator panel. If the cutter
boom lunges while cutting the stump the command cut is
set too slow. If machine stalls or is too agressive command
cut is set too fast. Additional adjustments can be made while
cutting the stump.
Note: Command Cut is only ON when the cutter wheel
is engaged. Settings will return to factory default when
key switch is turned to the off position.
Blade Transition for Transporting
The RG55 comes equipped with a 50 1/2” wide blade. For
convenience of trasporting through gates, or to load and
unload on and off a trailor, the blade has wings (16) that
can swing in to be only 34 1/2” wide.
To swing the blade wings inward, pull the clevis pins (17)
located on the back side of the blade. Simply turn the wings
inward, reinstall the clevis pins at holes (18) located on top
of blade to ensure they stay folded in.
15
18
16
17
To Next Page
Loading...
