Raymarine AXIOM 2 XL - Fitting the Gasket Tape

•A—Cutout(whenflushmountingthecutoutwillbethesamesizeas
forsurfacemounting.
•B—Flushmountingrequiresane xtrarebatetorecessthedisplayfullyin
themountingsurface.
1.Markthecutoutlineidentifiedonthesuppliedmountingtemplateon
themountingsurface.
2.MarktheRebateforflushmountlineidentifiedonthesuppliedmounting
templateonthemountingsurface.
3.Useadrillandanappropriatesizedrillbitorholecuttertocutoutthe
cornersoftheCutoutline.
Thecornerdiameterforthedisplaysare:
•15.40mm(0.61in)—Axiom®2XL16,19and24.
•13.5mm(0.53in)—Axiom®2XL22.
4.Useajigsaworsimilarcuttingtooltocutouttheremainderofthecut
outarea.
5.Usearouterhandtooltorecessthemarkedrebateareatoadepthof
9.00mm(0.35in).
6.Useahalfroundfileand/orsandpapertosmoothandroughedgesor
bursonthecutouthole.
7.6Fittingthegaskettape
Beforefittingthedisplayyoumustfitthemountinggaskettapetotherearof
thedisplay,asshownbelow.
1.Startingatthebottomcenter,affixthegaskettapetothedisplay.
2.Removethepaperbackingfromthetapebeforegoingaroundthe
corners,ensuringthatthetaperemainstightallaroundthedisplay,and
noairgapexistsbetweendisplayandtape.
3.Whenyoureachtheend,leaveasmalloverlaptoensurethatnogap
existsbetweentheendsofthegasketwhenitiscompressed.
Note:
Thesuppliedgaskettapeprovidesasealbetweentheunitandasuitably
flatandstiffmountingsurfaceorbinnacle.Thegasketshouldbeusedin
allinstallations.Itmayalsobenecessarytouseamarine-gradesealant
ifthemountingsurfaceorbinnacleisnotentirelyflatandstifforhasa
roughsurfacefinish.
32