Raymarine DSM300 - Chapter 4: Basic Display Controls; 4.1 Introduction; Simulator; 4.2 Setting Color and Brightness

Chapter 2: Transducer Installation 39
Figure 2-10: Transducer Fairing
Cutting the Fairing
1. Measure the deadrise angle of the hull at the selected location using a digital
level, or bubble level and protractor (see Figure 2-9 ).
2. Tilt the band saw table to the measured angle and secure the cutting fence
(see Figure 2-11 ).
Figure 2-11: Cutting the Fairing
⇐
Cutting guide
Triangular recess
for anti-rotation bolt
BOW
D5567-1
Cutting guide
Fence
Band saw table
Bow end for
installation
on port side
Deadrise
angle
D4860-2