How to fix weak Bluetooth signal on Raymarine Marine Equipment?
If you are experiencing a weak or intermittent Bluetooth signal with your Raymarine Marine Equipment, temporarily disable each wireless device in turn until you have identified the device causing the interference.
Why is my Raymarine Marine Equipment showing the wrong speed?
If you're getting an incorrect speed reading (DST) on your Raymarine Marine Equipment, check that the paddle wheel is clean. Add a speed offset if no speed offset is currently set. Re-calibrate the equipment. If the transducer does not have a speed element, install a transducer with a speed element to enable speed readings.
Why can't I switch between VIS/IR video on my Raymarine Marine Equipment?
If you cannot switch between thermal and visible (VIS/IR) video images on your Raymarine Marine Equipment, only 'dual payload' (dual lens) thermal cameras support VIS/IR switching. Ensure that the VIS/IR cable is connected from the camera to the Raymarine system.
General| Display Size | 9 inches |
|---|---|
| Display Resolution | 800 x 480 pixels |
| Touchscreen | Yes |
| Chartplotter | Yes |
| Sonar Support | Yes |
| Radar Compatible | Yes |
| Wi-Fi | Yes |
| Bluetooth | Yes |
| Networking | NMEA 2000, Ethernet |
| Video Input | Yes |
| Waterproof Rating | IPX6 |
| Display Type | Color LCD |
| Cartography | Navionics |
| Operating Voltage | 12 V DC / 24 V DC |
| Weight | 3.2 lbs |
| GPS Receiver | Built-in 50 channel |
To Next Page
